Welcome to Nantong Fleck Fluid Equipment CO., LTD.!

Technology R & D

Home

Operation precautions of dispersing emulsifying machine

dispersion emulsifying machineIt is widely used, because it has various advantages and characteristics, it is recognized by everyone, and it is easier to operate. Only in strict accordance with the operating regulations to use, in order to achieve good results, the following let's understand the dispersion of emulsifying machine selection matters needing attention.

dispersion emulsifying machineThe material is sheared, dispersed and impacted by the high-speed rotation of the homogenizer head connected to the engine. In this way, the material will become more delicate, and you will find that the oil and water will merge together during operation. Widely used in cosmetics, shower gel, sunscreen and many other need to use dispersing emulsifier cream products. Sauce, juice, etc. Actually in the food industry. Ointments for the pharmaceutical industry. The dispersing emulsifying machine will be used in petrochemical industry, paint, coating, ink, etc. In addition, each time the user starts the dispersing emulsifier, he should first open the bearing water jacket to make the water circulate, and dry operation is strictly prohibited. Of course, if it is started on duty during use, the dispersing emulsifier should be inched first, and then started to prevent excessive starting load from burning the motor. The jog test run time should not exceed20Seconds. During the operation of the dispersing emulsifier, it is strictly forbidden to cut off the water at the bearing water jacket and shell. Of course, in the working process, it is strictly forbidden to break the materials of the dispersing emulsifier, so as to prevent the latex from staying and heating up and prevent accidents. Of course, after the end of the production, the dispersing emulsifying machine must be washed clean with water, and it is strictly prohibited to start the dispersing emulsifying machine with load.

When the dispersing emulsifying machine is running, it should be noted that the materials in the emulsifying room must be cleaned up before the dismantling or maintenance of the dispersing emulsifying machine. In order to ensure production safety and avoid human misoperation, it is recommended that the equipment must be equipped with automatic alarm and automatic shutdown functions for process parameters such as overtemperature, overpressure and truncation during the operation and control of continuous emulsification. Safety measures such as power failure, water failure, abnormal current fluctuation, etc..In addition, we also need to note that the dispersing emulsifier has undergone strict dynamic balance inspection, water jacket pressure inspection and machine operation test before leaving the factory. However, after long-distance transportation, the user should check whether the bolts in each part are loose before use, and apply grease on the bearing. Turn the coupling by hand to see if it is stuck. After confirming that there is no difference, it can be installed and debugged and put into use. Bearings should be lubricated frequently and grease every two weeks. Lithium grease or molybdenum disulfide grease is recommended. Especially now, users conduct a comprehensive maintenance of the equipment every six months after continuous operation to check whether the bearings, stators, rotors and connectors are in good condition. And in the working process, the dispersion emulsifying machine itself has a bad phenomenon to stop, diagnosis and maintenance before the boot. Work with illness is prohibited.

The above article content we tell you about the relevantdispersion emulsifying machineIf you don't know the operation precautions, then come and have a look. That's all about this knowledge. I hope I can help you.