Welcome to Nantong Fleck Fluid Equipment CO., LTD.!
The following points should be paid attention to when using high shear dispersing emulsifying machine
Tell everyone below to use high sheardispersion emulsifying machinePay attention to the following points
Pay attention to the following points when using high shear dispersion emulsifying machine
The high-shear dispersion emulsifying machine is mainly used for emulsification and homogenization process. It uses the high-shear linear velocity generated by the high-speed rotation of the rotor and the strong kinetic energy brought by the high-frequency mechanical effect, so that the material is strongly affected in the narrow gap between the stator and the rotor. The combined effects of mechanical and hydraulic shearing, centrifugal extrusion, liquid layer friction, impact tearing and turbulence, make the immiscible solid phase, liquid phase and gas phase in the corresponding mature process and the right amount of additives under the joint action, after high-frequency cycle, instant dispersion emulsification uniform, the use of high shear.dispersion emulsifying machineWhen, pay special attention to the following points:
1. If there is any abnormal sound or other fault during operation, stop the machine immediately for inspection, remove the fault before operation, and clean the working chamber, stator and rotor after shutdown.
2. For example, the process studio can be equipped with a thermal insulation layer for cooling or heating materials. When starting, first turn on the coolant or heat transfer oil. The working pressure of the interlayer insulation is 0.2mpa. When there is a temperature requirement in the processing, it must be heated or Cool to normal working temperature, open and start.
3. When used in a flammable and explosive working environment, the corresponding grade of explosion-proof motor must be selected.
4. After the end of production, the equipment must be cleaned, so as to maintain the efficiency of the stator and rotor, but also to protect the seal of the machine, if necessary, design and install a set of cleaning cycle device near the periphery.
5. According to the different media used by the user, the inlet and outlet filters must be cleaned regularly to avoid reducing the feed volume and affecting the production efficiency. The materials entering the working chamber must be fluid. Dry powder and block materials are not allowed to enter the machine directly, otherwise it will be stuffy. Machine, damage the equipment.
6. Check the stator and rotor regularly. If excessive wear is found, replace the corresponding parts in time to ensure the effect of dispersion and emulsification.
7. If shaft fluid leakage is found during operation, the sealing pressure of the machine must be adjusted after shutdown.
8. Use high sheardispersion emulsifying machineBefore the equipment, it is necessary to formulate corresponding safe production operation procedures to ensure the safety of operators and equipment. Users should set up a safety protection system in the electrical control system, and have good and reliable electrical and motor grounding devices.
The above is the content of "pay attention to the following points when using the high-shear dispersing emulsifier" explained by the manufacturer of the dispersing emulsifier. I hope the above content can help you better understand and use this high-shear dispersing emulsifier equipment. Thank you for watching. See you next time.
Recommended Information
Crushing pump - pigment crushing test
2023-11-30
Precautions for operating an emulsifier
2023-11-14
Delivery of hygienic rice grinder
2023-11-07
Polyacrylamide mixed homogenization test
2023-10-23
Contact Information
No. 5, Youth East Road, Science and Technology Pioneer Park, Qidong City, Jiangsu Province
Focus on us
Mobile Website
Copyright©2023 Nantong Fleck Fluid Equipment CO., LTD.
Powered by 300.cn | SEO | Business License